Here we give you advice and suggestions about robotic lawn mowers and how you can take the best advantage of all opportunities offered to owners of Husqvarna Automower®.



To neaten an edge with a grass trimmer at the lawn edge against a hedge pack mulch bark so that the mower can go on top of the base, add a loop approximately 10 cm onto the grass. The Automower® has the default setting of 25 cm as it goes over the loop, making it even out the grass. The same can be done around e.g.fruit trees and the like. View image 3.

Alongsigde the house, flower beds, you can dig out 15 * 15 cm and put in a ground cloth, re-fill with fine gravel or stone chips well packed up to lawn level or on top of the stone chips make a nice paving blocks level with the lawn surface that the robotic lawnmower can "go on ".

If the lawn faces a pathway or similar, add the loop of wire about 10 cm onto the lawn so that the robot lawnmower goes out a bit on the pathway so you do not have to cut the edges with a grass trimmer. See picture 2, 3, 4.

Problems with the killer snails? This is where the Husqvarna Automower ® is helpful. Make sure you set the timer so that the robotic mower cuts the grass when the killer snails are most active, which is usually at dusk and early morning. Alternatively, depending on the plot size, would be for the Automower® to mow constantly during the day.